LABORATORY

Our Laboratory

Our laboratory was started in the year 2013. Our in-house laboratory is a supporting division for assuring the quality of its products. To keep up with our quality standards, we have experienced technicians and analysts. Our testing methods are as per International and Indian quality standard metrics. We have separate physical and chemical divisions for textile and chemical testing. Our chemical division has imported equipment with advanced technology, while our physical laboratory is fully conditioned with humidification facility using modern technology for yarn testing.






A part from in- house day-to-day testing we do testing for customer requirements as an additional service. In our laboratory, more than 30 parameters are tested which includes textile sizing auxiliaries, fibre, yarn, fabric, water testing and more. We do R&D in textile sizing in our laboratory mainly on polymers.


Physical Division Instruments

  • Auto wrap XT
is a motorized wrap reel machine with 5 bobbins. It is used to wind hanks from bobbins.
  • Auto wrap XT
is a motorized wrap reel machine with 5 bobbins. It is used to wind hanks from bobbins.
  • Auto Stretch SC
is used to calculate single yarn gram force, newton force, elongation and rkm value.
  • Abra Test
for measuring the abrasion resistance of yarn.
  • Auto Winder DXT
Is used to analyze Thin place, Thick place, Slub and Neps.





Physical Division Instruments Testing Parameters

  • Count Calculation of yarn.
  • Single yarn Strength.
  • Lea Strength
  • Abrasion Resistance of yarn
  • Yarn Appearance

Chemical Division Instruments & Equipments

  • Hot air oven
  • is used to determine heat resistance and behaviour of the material in elevated temperatures.

  • Muffle furnace
  • is used to determine the ash content of polymer, polyethylene, polyester, nylon, cork etc.

  • BOD incubator
  • is used to test materials under lab controlled atmosphere in terms of humidity, temperature and more.

  • Melting point apparatus
  • is built in with micro-controller based system and precise temperature controller for accurate results.

  • pH Meter
  • is used to evaluate the Ph value of any solution.



  • Penetrometer
  • is used to calibrate characterisation of hydrophobization properties of material to establish the optimum formulas of water resistant finishing.

  • Moisture Balance
  • is to check the moisture balance in the material to enable optimum quality.

  • COD reactor
  • is used to remove dye and Chemical Oxygen on Demand to bring down the water waste during the manufacturing process.

  • COD analyser/ Multiphotometer
  • is used to do waste water treatment during the manufacturing process to bring down the chemical waste.

  • BOD analyser
  • is used to analyse the toxicity, BOD and COD in the manufacturing waste.

  • Brookfield Viscometer
  • is used to analyse the relative viscosity of the polyamide in the material.

    Chemical Division Instruments & Equipments Testing Parameters

  • pH of aqueous solution
  • Desizing Efficiency (TEGAWA Rating)
  • Total Solids
  • Viscosity (Ford Cup, Brookfield)
  • Hardness of water
  • Total Dissolved Solids
  • Moisture Content
  • Acid Value
  • Total Suspended Solids
  • Ash Content
  • Alkalinity
  • Saponification Value
  • Permanganate Value
  • Melting Point
  • COD Value
  • Volatile Solids
  • Needle Penetration
  • BOD Value
  • Fixed Solids
  • Purity of Starch
  • Film Preparation
  • Chloride
  • Film Preparation
  • Chloride
  • Purity of PVA
  • Solid Content
  • Acidity
  • Active Matter Content in CMC
  • Total Fatty matter
  • Size Pick Up
  • Heavy metals analysis
  • Purity of Chemicals
  • Our Laboratory Images

    WordPress Video Lightbox Plugin